Ultra1500 Connector Data; Chapter Objectives; Understanding Ultra1500 Connectors - Allen-Bradley Ultra1500 2092-DA1 User Manual

Chapter Objectives

Understanding Ultra1500
Connectors
Designator
CN1
CN2
CN3
Input Power
DC Bus and
Shunt Power
Output Power
1 DC Bus Negative is labelled DC- on the removable connector, but N is embossed on the drive cover.
1

Ultra1500 Connector Data

This chapter provides I/O, encoder, and serial interface connector locations
and signal descriptions for your Ultra1500. This chapter includes:
•

Understanding Ultra1500 Connectors

•
Understanding Ultra1500 I/O Specifications
•
Understanding Ultra1500 Motor Encoder Feedback Specifications
•
Understanding Ultra1500 Power and Ground Connections
•
Understanding the Ultra1500 Serial Interface
The following table provides a brief description of the Ultra1500 front panel
connectors and describes the connector type.
Description
User Input/Output
Motor Feedback
Serial Port
Main AC Power (L1–L3),
Control AC Power (L1C, L2C),
1
and DC Bus Negative (N)
Diode Bridge Output (P1),
DC Bus Positive (P2), and
Shunt Resistor (B1–B2)
Motor Power Phases
(U, V, and W)
The N terminal (labelled DC- on the removable connector) IS NOT an
ATTENTION
Input Power connection.
!
Connector
50-pin, mini-D
20-pin, mini-D
20-pin, mini-D
Six-position, single row, spring clamp connectors with 7.5 mm spacing
(Wago 231-206/026-000)
Four-position, single row, spring clamp connectors with 7.5 mm spacing
(Wago 231-204/026-000)
Three-position, single row, spring clamp connectors with 7.5 mm spacing
(Wago 231-203/026-000)
Publication 2092-UM001D-EN-P — July 2005
2
Chapter