Starting The Tractor; Adjusting The Operator's Position; Operator's Seat; Seat Belt - Kubota B2401DT Operator's Manual

OPERATING THE TRACTOR
2. If you feel less friction in folding the ROPS, tighten
the nut (1) until you feel the right friction in the
movement.
(1) Nut

STARTING THE TRACTOR

1. Adjusting the operator's position

1.1 Operator's seat

WARNING
To avoid personal injury or death:
• Make sure that the seat is completely secured
after each adjustment.
• Do not allow any person other than the driver to
ride on the tractor.
• Position adjustment
Pull in the position adjust lever and slide the seat
backward or forward, as required.
The seat will lock in position when the lever is
released.
(1) Seat
(2) Position adjust lever
IMPORTANT :
• After adjusting the operator's seat, be sure to
check that the seat is properly locked.
32
(A) Pull in

1.2 Seat belt

WARNING
To avoid personal injury or death:
• Always use the seat belt when the ROPS is
installed.
• Do not use the seat belt if a foldable ROPS is
down or there is no ROPS.
Adjust the seat belt for proper fit and connect to the
buckle. The seat belt is auto-locking retractable type.
(1) Seat belt
2. Operator presence control (OPC)
system
The tractor is equipped with a system which stops the
PTO and activates a warning buzzer. This system is
tripped under the following conditions.
When the tractor is stopped:
• With the seat unoccupied or tilted up, do not move
the PTO gear shift lever from the "NEUTRAL"
position to the "1st" or "2nd" position. The OPC is
tripped to stop the engine and activate the warning
buzzer.

3. Selecting light switch position

3.1 Head light / turn signal / hazard light
switch
Head light switch
[OFF] (A)
Head lights are OFF.
(B)
Head lights are ON.
Hazard light
When hazard light switch is pushed, the hazard lights
flash, along with the LH and RH indicators on the
instrument panel.
Push hazard light switch again to turn off the hazard
lights.
STARTING THE TRACTOR
B2401DT, B2401DTWO, B2401DTN