Avaya S6200 Administration And Maintenance page 81

Note:
Bridge Talk refers to the autoconf setting as "ACS".
Note:
When assigning conference numbers to unattended conferences, the system uses the first
available (inactive) conference with the lowest conference number. To prevent conflicts on
systems running both ACS and unattended lines, specify high-numbered conferences for
ACS.
The autoconf command defaults the ACS setting to 0, which means that callers are routed
to the Enter queue or conferences specified by other call processing features (e.g., Call
Routing, unattended services).
Note:
When you use autoconf to turn ACS on for a port, that port must have its Call
Note:
Routing set to "N". The call route setting will override the autconf setting if both
are set to "Y." For additional information on call routing refer to
81.
The system considers conferences using ACS lines as unattended, even if you provide
operator support such as Help, Q&A, and Polling. Therefore, the system clears the
conference minutes, name, and ID when the conference ends (the last conferee
disconnects) regardless of the system Automatic Conf. Clear parameter setting (see
Chapter 4: Configuring System-Wide Settings
answer
Use the answer command to determine how the system will process calls arriving on a
particular port.
Set the answer values for the IPD:
Y (default) — the system answers all incoming calls.
l
N — Prevent the port from accepting incoming calls, perhaps to reserve the port for
l
dialing out.
Note:
You can override the answer settings using Bridge Talk's Set Answer option. See
Note:
the ACS Managing and Scheduling Conferences Guide for more information.
routecall
The routecall command setting enables or disables the system's Call Routing feature for
system channels.
Set the call routing values for the IPG:
N — Disable call routing.
l
Note:
When ACS is turned on for a channel, that channel must have its Call Routing set
Note:
to "N".
Establishing Port Groups
for more information).
Issue 1
routecall on page
August 2007 81