Table of Contents
Advertisement
Configuring System-Wide Settings
Table 16: Flex Configuration Settings (continued)
System Administrator
Main Menu >
Configure Scheduler
Configure Scheduler
Configure Conference Scheduler, Flex settings
78 Administration and Maintenance of the S6200/S6800 Servers
Parameter / Setting
Flex Maximum Dial
Out Digits
Flex Leader Pin Modify
+-------Configure Conference Scheduler--------+
¦
¦ Flex Short Time (3-20)
¦ Flex Short Attempts (1-5)
¦ Flex Long Time (5-60)
¦ Flex Long Attempts (1-3)
¦ Flex Minimum Dial Out Digits
¦ Flex Maximum Dial Out Digits
¦ Flex Leader Pin Modify
¦ NRP-Oper Timeout (Last Attempt): Conf
¦
¦
+------ More-Next/Prev Page ESC to Exit ------+
To
Specifies the maximum number of digits
allowed for dial out.
Select one of the following
conference-wide settings:
ENABLED (Default). The
l
moderator (leader) can modify a
Leader PIN by pressing 2 on a
telephone keypad to access the
Default Conference Options menu
before the conference starts.
DISABLED. The moderator cannot
l
modify a Leader PIN in the Default
Conference Options menu before
the conference starts.
Refer to the
Configure Conference
Scheduler, Flex settings
The minimum Leader PIN length is set to
4; the maximum length is set to 16.
Currently, you cannot modify these
values.
If a conference leader changes the
default Leader (moderator) PIN code
before the conference starts, the system
prompts the leader to enter a number
that falls within the minimum and
maximum settings.
: 5
: 3
: 40
: 1
: 4
: 12
: ENABLED
below.
3 of 3
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
Advertisement
Table of Contents
