Avaya S6200 Administration And Maintenance page 138

Configuring Conference Scheduler
Table 25: Conference Scheduler Configuration Parameters (continued)
Parameter
Flex Leader
Pin Modify
(Flex only)
NRP Timeout
(Last Attempt)
Tip:
For instructions on using DTMF commands to change Flex conference settings,
Tip:
see Appendix A of the Bridge Talk User's Guide.
138 Administration and Maintenance of the S6200/S6800 Servers
Description
Select one of the following conference-wide settings:
Enabled (Default)—The moderator (leader) can modify
l
a Leader PIN by pressing 2 on a telephone keypad to
access the Default Conference Options menu before
the conference starts.
Disabled— The moderator cannot modify a Leader PIN
l
in the Default Conference Options menu before the
conference starts.
The minimum Leader PIN length is set to 4; the maximum
length is set to 16. Currently, you cannot modify these values.
If a conference leader changes the default Leader
(moderator) PIN code before the conference starts, the
system prompts the leader to enter a number that falls within
the minimum and maximum settings.
When Name Record/Playback is set to OPER in the
conference scheduler, this setting specifies where the system
places a participant who fails to press "#" after recording his
name.
Conf (Default)—The system places participants who
l
record a name, but who do not press #, into the
conference.
Enter—The system places participants who record a
l
name, but who do not press #, into the Enter queue.
6 of 6