Configuring System-Wide Settings
3. Save (or cancel) your changes
.
Table 12: Supervision Configuration Parameters
Parameter
Annunciator Delay
Dial Delay
64 Administration and Maintenance of the S6200/S6800 Servers
Description
Specifies the pause before the system plays a message to an
incoming line.
To specify a delay enter a value of 1 to 5 seconds (0 is the
default).
To determine if a delay is necessary, simply dial into the system
and listen to the annunciator message.
Specifies the pause (line remains off hook) before the system
begins dialing digits.
This delay verifies dial tone. Valid time intervals range from 1
(default) to 5 seconds. Consult your phone network provider to
determine the most suitable dial delay for your system.
Note:
Not supported in this release.
Note:
1 of 3