Avaya S6200 Administration And Maintenance page 74

Configuring System-Wide Settings
4. Enter the parameter values you want.
5. Save (or cancel) your changes.
Table 15: Operator Configuration Parameters
Parameter
Printing
Beep Mode
Beep Time
Remote
(audio)
74 Administration and Maintenance of the S6200/S6800 Servers
Table 15
Description
Not implemented
The system plays a tone when the system places a conferee in
the Enter Queue, Help Queue, or Disconnect Mode. Entry tones
apply on a per conference basis.
No Beep —Do not beep.
l
Single Beep (default) — Play a 1-beep tone.
l
Continuous Beep — Play a beep every one to five seconds
l
(as specified by the Beep Time parameter).
Specifies the duration in seconds (1 - 5) between beeps (if
Continuous Beep is specified for the Beep Mode parameter). The
default is 5.
Specifies whether or not a revenue channel is used for the
operator audio path instead of an FDAPI operator channel:
Y — Use a revenue channel for the operator audio path.
l
(You specify the number of the revenue channel to which
you want to assign the audio path with the Channel
parameter.)
N (default) — Use the FDAPI channel for the operator
l
audio path. (You specify N when you want to convert the
audio path from a revenue channel (Y) back to an FDAPI
channel, which is specified by the Channel parameter.)
Note:
Switching the operator audio path from an FDAPI
Note:
Operator channel to a remote channel (Y) does
not "free" an FDAPI Operator channel configured
for the system.
lists and describes parameters.
1 of 2