Avaya S6200 Administration And Maintenance page 66

Configuring System-Wide Settings
Table 12: Supervision Configuration Parameters (continued)
Parameter
Disconnect
Notification
Wink Timeout
Line Fault
66 Administration and Maintenance of the S6200/S6800 Servers
Description
Specifies whether or not disconnect messages appear on
operator workstation displays. Disconnect Notification provides
operators with additional information about a disconnecting line.
ON — The following message appears on the chat line of
l
each active workstation when a qualifying line disconnects:
O: DC: 0001 NAME C:0003 NAME
where:
0 = Global Message
DC = Message Type(Disconnect)
0001 = Line Number
NAME = Line Name
C:0003 = Conference Number
NAME = Conference Name
This information is helpful in determining whether to
re-establish the connection or alert the conference
moderator of the disconnect. Like Disconnect Mode, the
Disconnect Notification only applies to attended calls that
were dialed from the bridge and hung up by the participant
(far end). Thus, the workstation quickly posts numerous
messages to the chat window.
OFF (default) — Operators are not provided disconnect
l
information.
Specifies how long the system waits for wink-back from the far
end before disconnecting the line.
Note:
Not supported in this release.
Note:
Specifies whether or not the system takes faulted lines off-hook.
Operators fault lines to take them temporarily out of service.
OFF — Faulted lines remain on hook, but the system
l
ignores dial-ins and does not allow dial-outs. Incoming
calls receive a ring, but the call is not answered.
ON (default) — Faulted lines are taken off hook so that
l
incoming calls receive a busy signal.
3 of 3