Basic hardware procedures
4.4.2
Extending the server out of the rack
CAUTION
▶
Use the anti-tilt plate to prevent the rack from tipping when
installing the rack. Pulling the server out of the rack without having
installed the anti-tilt plate may cause the rack to tip over.
▶
Be careful not to pinch fingers or clothes when sliding out the
server or pushing it back. Failure to do so may cause injury.
▶
For maintenance procedures on the system board the rack must be
pulled out of the server and put on a even surface.
▶
Be careful not to damage the rack rails when sliding out the server
or pushing it back. Damaged rack rails may cause injury.
▶
For more information, see
▶ Be careful not to disconnect external cables from the I/O panel and
expansion cards.
▶ If you are not using a Cable Management Arm (CMA), ensure that the rear
cables are long enough not to be strained or damaged when extending the
server out of the rack.
Figure 3: Extending the server out of the rack
48
"Important information" on page
Upgrade and Maintenance Manual
29.
RX4770 M5