Adjusting Magnification Of The Scanner In The Main Scanning Direction - Kyocera Mita KM-1530 Service Manual

2AV/X

(8) Adjusting magnification of the scanner in the main scanning direction

Perform the following adjustment if the magnification in the main scanning direction is not correct.
U053
(P. 1-4-11)
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Also, perform "(9) Adjusting magnification of the scanner in the auxiliary scanning direction" (page 1-6-34) and "(11)
Adjusting the scanner center line" (page 1-6-37) after this adjustment.
Procedure
• 20 cpm
Enter "065" using the numeric keys.
1-6
1-6-32
U065
(main scanning (auxiliary scanning
direction) (P. 1-6-34)
direction)
Start
Enter maintenance mode.
Press the start key.
Select "MAIN SCAN ADJ"
(main scanning direction).
Press the interrupt key.
Place an original and press
the start key to make a test copy.
Is the image correct?
Yes
Press the stop/clear key to
exit maintenance mode.
End
U065
U067
(P. 1-6-37)
Original
Press the start key.
The new setting
For copy example 1, increase the
value using the cursor right key.
No
For copy example 2, decrease the
value using the cursor left key.
Setting range: –25 – +25
Initial setting: 0
Changing the value by 1 changes
the magnification by 0.1%.
Increasing the value makes
the image wider, and decreasing it
makes the image narrower.
Copy Copy
example 2
example
Figure 1-6-49a
is stored.