Kyocera Mita KM-1530 Service Manual page 81

2AV/X
Maintenance
item No.
U207 Checking the operation panel keys
Description
Checks operation of the operation panel keys.
Purpose
To check operation of all the keys and LEDs on the operation panel.
Method
1. Press the start key. The screen for executing is displayed.
2. "1" appears on the copy quantity display and the leftmost LED on the operation panel lights.
3. As the keys lined up in the same line as the lit indicator are pressed in the order from the top to the
bottom, the figure shown on the copy quantity display increases in increments of 1. When all the keys in
that line are pressed and if there are any LEDs corresponding to the keys in the line on the immediate
right, the top LED in that line will light.
4. When all the keys on the operation panel have been pressed, all the LEDs light for up to 10 seconds.
5. When the LEDs go off, press the start key. All the LEDs light for 10 seconds again.
• If an optional fax unit is installed, proceed with checking the fax keys. Opening the rear panel cover
after pressing the last key will light all the LEDs.
Completion
1-4
Press the stop/clear key at the screen for executing. The screen for selecting a maintenance item No. is
displayed.
• After checking numeric key 1, the operation cannot be canceled until all the keys are checked.
U210 Reversing the LCD
Description
Sets whether to reverse the message display (LCD) in the operation panel.
Purpose
To reverse the message display.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select ON or OFF using the cursor up/down keys.
ON
OFF
Initial setting: OFF
2. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key. The screen for
selecting a maintenance item No. is displayed.
U211 Setting DF type
Descrioption
Sets the optional DF type (STDF or SRDF).
Purpose
To set DF type when installing.
Method
1. Press the start key. The screen for selecting an item is displaued.
2. Select DF type using the cursor up/down keys.
SADF
SRADF
3. Press the start key.
1-4-32
Display
Reverse
Normal
Display
Single-sided (STDF)
Double-sided (SRDF)
Description
Description
Description