Kyocera Mita KM-1530 Service Manual page 294

Maintenance
Section
part/location
Optical section Original size detection
(con.) sensor
Maintenance
Section
part/location
Developing Developer
section
Drum unit
Charger assembly
Cleaning lamp
Transfer roller assembly
Doctor blade cover
Seals
Maintenance
Section
part/location
Cleaning Cleaning blade
section
Drum separation claw
Drum shaft
Front drum bushing
Rear drum bushing
Cleaning lower seal
Seals
Method Maintenance cycle
Clean Every service
Method Maintenance cycle
Replace Every service
Replace Every service
Replace Every service
Clean Every service
Clean Clean after every
100,000 counts
Check and grease After every
100,000 counts
Replace Every 200,000 counts
Clean Clean after every
100,000 counts
Replace Every 200,000 counts
Clean Every service
Method Maintenance cycle
Replace Every service
Check or replace Every service
Clean Every service
Clean Every service
Clean Every service
Check or replace After 200,000 counts
Clean Every service
Points and cautions
Clean the sensor emitter and
receiver with alcohol and then a
dry cloth only if there is a problem.
Points and cautions
Apply GE-334C conductive
grease (P/N A0199040) between
the drum shaft and grounding
plate.
Clean with a dry cloth.
Vacuum or clean with a dry cloth
(take care not to damage the
transfer roller).
Check noise. If noise is heard,
apply grease G501 to the
following locations:
• Contacting surfaces of the
transfer roller and collar
• Contacting surfaces of the
transfer roller and bushing
• Contacting surfaces of the gear
and collar
Check noise. If noise is heard,
apply conductive grease GE334
to the following locations:
• Contacting surfaces of the
transfer roller, bushing and
terminal
Clean with a dry cloth (take care
not to damage the doctor blade
cover).
Vacuum or clean with a dry cloth.
Points and cautions
Clean with a dry cloth; replace
if the tip is deformed.
Clean with a dry cloth.
Clean with a dry cloth.
Clean with a dry cloth.
Replace if toner spills due to
wavy or deformed edges of
the seal.
Vacuum or clean with a dry cloth.
2AV/X
Page
Page
1-3-8
1-6-43
1-6-40
1-6-45
Page
1-6-46
1-6-43
1-6-47
2-4
2-4-13