Kyocera Mita KM-1530 Service Manual page 295

2AV/X
Section
Fixing/Eject
section
Section
Covers
Section
Other
• Optional drawer
Section
Test copy and
test print
Section
Paper feed
section
2-4
2-4-14
Maintenance
part/location
Heat roller Clean or replace
Press roller Clean or replace
Bushing Check and replace
Bearing Check and replace
Fixing unit themistor Check and clean
Heat roller separation claw Clean or replace
Fixing heater Check and replace
Gear Check and replace
Eject roller Clean
Eject pulley Clean
Eject roller Clean and grease
Maintenance
part/location
Covers Clean
Maintenance
part/location
Image quality Check and adjust
Maintenance
part/location
Perform at the maximum Test copy
copy size
Maintenance
part/location
Paper feed pulleys Clean
Check
Paper feed roller Clean
Bushings Check
Method Maintenance cycle
Clean after 100,000
counts; check and
replace after 200,000
counts
Clean after 100,000
counts; check and
replace after 200,000
counts
After 200,000 counts
After 200,000 counts
After 200,000 counts
After 200,000 counts
After 200,000 counts
Every service
Every service
Every service
Every service
Method Maintenance cycle
Every service
Method Maintenance cycle
Every service
Method Maintenance cycle
Every service
Method Maintenance cycle
Every service
Every service
Every service
Every service
Points and cautions
Clean with alcohol.
Clean with alcohol.
Check the installation position
and noise.
Check the installation position
and noise.
Clean with alcohol and check for
peeling of the film.
Clean with alcohol.
Check if the lamp is dark or not.
Check for chips in the gear.
Clean with alcohol or a dry cloth.
Clean with alcohol or a dry cloth.
Check noise. If noise is heard,
apply grease TMP1-200G to the
contacting surfaces of the eject
roller and bushing.
Points and cautions
Clean with alcohol or a dry cloth.
Points and cautions
Points and cautions
Points and cautions
Clean with alcohol or a dry cloth.
Check the leading edge
registration and paper feed
conditions in the registration
section, bypass and paper feed
section.
Clean with alcohol or a dry cloth.
Check noise. If noise is heard,
apply grease TMP-200G.
Page
1-6-51
1-6-53
1-6-51
1-6-53
1-6-49
1-6-49
1-6-50
1-6-51
Page
Page
Page
Page