Kyocera Mita KM-1530 Service Manual page 205

8. Loop the inner ends of the scanner wires around the grooves in the pulleys at the right of the scanner unit,
winding from below to above. ......................................................................................................................... 1
9. Loop the scanner wires around the inner grooves in the pulleys on the mirror 2 frame, winding from above to
below. .............................................................................................................................................................. 2
10. Hook the round terminals onto the catches inside the scanner unit. .............................................................. 3
11. Loop the outer ends of the scanner wires around the grooves in the scanner wire pulleys at the left of the
scanner unit, winding from below to above. .................................................................................................... 4
12. Loop the scanner wires around the outer grooves in the pulleys on the mirror 2 frame, winding from below to
above. ............................................................................................................................................................. 5
13 Wind the scanner wires around the grooves in the scanner wire guides at the left of the scanner unit. ......... 6
14. Hook the round terminals onto the scanner tension springs. .......................................................................... 7
15. Remove the scanner wire stoppers and frame securing tools.
16. Gather the scanner wires toward the locating balls.
17. Move the mirror 2 frame from side to side to correctly locate the wires in position.
18. Refit all the removed parts.
Figure 1-6-33
Figure 1-6-34
2AV/X
1-6
1-6-23