Kyocera Mita KM-1530 Service Manual page 174

2AV/X
(12) The leading edge of
the image is sporadi-
cally misaligned with
the original.
1. Registration clutch, bypass paper feed clutch
or paper feed clutch installed or operating
incorrectly.
(13) Paper creases.
1-5
1. Paper curled.
2. Paper damp.
3. Defective pressure springs.
(14) Offset occurs.
1. Defective cleaning blade.
1-5-22
Causes
1. Registration clutch, bypass paper feed clutch
or paper feed clutch installed or operating
incorrectly.
Causes
Causes
1. Paper curled.
2. Paper damp.
3. Defective pressure springs.
Causes
Causes
1. Defective cleaning blade.
Causes
Check procedures/corrective measures
Check the installation position and operation of the registration
clutch, bypass paper feed clutch and paper feed clutches. If any of
them operates incorrectly, replace it.
Check procedures/corrective measures
Check the paper storage conditions.
Check the paper storage conditions.
Replace the pressure springs.
Check procedures/corrective measures
Replace the cleaning blade (see page 1-6-46).