Kyocera Mita KM-1530 Service Manual page 64

Maintenance
item No.
U071
Adjustment
1. In interrupt copy mode, make a copy using the DF.
2. Check the copy image and adjust the registration as follows.
For copy example 1, increase the setting of LEAD EDGE ADJ.
For copy example 2, decrease the setting of LEAD EDGE ADJ.
Completion
Press the stop/clear key at the screen for selecting an item. The screen for selecting a maintenance item
No. is displayed.
U072 Adjusting the DF center line
Description
Adjusts the scanning start position for the DF original.
Purpose
To be executed if there is a regular error between the centers of the original and the copy image when the
optional DF is used.
Caution
Before making this adjustment, ensure that the following adjustments have been made in maintenance
mode.
U034 U067 U072
Method
Press the start key.
Setting
1. Change the setting using the cursor left/right keys.
Description
DF center line
Increasing the setting moves the image to the right, and decreasing it moves the image to the left.
2. Press the start key. The value is set.
Interrupt copy mode
While this maintenance item is being performed, copying from an original can be made in interrupt copy
mode.
Description
Original Copy
example 1
Figure 1-4-2
Setting range Initial setting Change in value per step
–39 to +39 0
Copy
example 2
0.17 mm
2AV/X
1-4
1-4-15