Kyocera Mita KM-1530 Service Manual page 187

• Lower peper feed pulleys (optional for the 15 cpm copier)
1. Open the lower drawer left cover and pull the
lower drawer out.
2. Remove the two screws holding the rear
cover of the lower drawer and then the cover.
3. Turn the drawer drive motor clockwise and
rotate the paper feed shaft unit so that the
screws holding the lower paper feed pulleys
can be seen when the left cover is opened.
4. Remove the screws holding each of the lower
paper feed pulleys and then the pulleys.
5. Replace the lower paper feed pulleys and
refit all the removed parts.
• Before returning the drawer, turn the main
switch on and check that the lower paper
feed pulleys are positioned correctly (the
semicircular pulleys should be facing
downward).
Drawer drive motor
Figure 1-6-7
Lower peper feed pulleys
Screws
Figure 1-6-8
2AV/X
1-6
1-6-5