Kyocera Mita KM-1530 Service Manual page 32

2. Check that the cleaning shaft is inserted as far as
it will go.
3. Refit the image formation unit using the two
screws.
4. Connect the 12-pin connector.
Install a waste toner tank.
1.While holding the waste toner tank release lever
up, fit the waste toner tank in the copier.
2. Close the front cover.
Adjust the fixing pressure.
1. Remove the two blue screws.
2. Close the paper conveying unit and the bypass
tray.
12-pin connector
Figure 1-3-13
Waste toner tank
release lever
Figure 1-3-14
Blue screws
Figure 1-3-15
2AV/X
1-3
Waste toner tank
1-3-9