Enlargement/Reduction; Auto Magnification Selection Mode; Zoom Copy Mode - Kyocera Mita KM-2030 Instruction Handbook Manual

2. Enlargement/reduction

(1) Auto magnification selection mode

The original image is enlarged/reduced automatically according to the
selected paper size.
IMPORTANT
• When using this mode regularly, make sure that "AMS" has been
selected in "8 AMS MODE" on page 6-12.
1
Set the original(s).
The size of the original will be automatically detected and the
same size paper as the original will be selected.
NOTE
• If "100%" has been selected in "8 AMS MODE" on page 6-12,
press the Manual key to display "AMS".
CHAPTER 4 BASIC OPERATION
2
Press the Paper Select key to specify the paper size.
The magnification ratio will be displayed.
3
Copying will start when the Start key is pressed.

(2) Zoom copy mode

The zoom ratio can be set to any value from 50 to 200% in 1%
increments.
1
Set the original(s).
2
Press the Zoom (+) or Zoom (–) key to change the displayed
zoom ratio.
Press the Paper Select key to change the paper size.
3 Copying will start when the Start key is pressed.
4-4