Kyocera Mita KM-1530 Service Manual page 134

Maintenance
item No.
U204 Setting the presence or absence of a key card or key counter
Description
Sets the presence or absence of the optional key card or key counter.
Purpose
It is not necessary to run this maintenance item if a key card is installed on a 120 V specification machine. A key
card is not available for 220 – 240 V specifications.
Method
Press the start key.
Setting
1. Select the optional counter to be installed using the zoom +/– keys.
Display
– – –
C-1
C-2
2. Press the start key. The setting is set and the indication for selecting a maintenance item No. appears.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key. The indication for
selecting a maintenance item No. appears.
U207 Checking the operation panel keys
Description
Checks operation of the operation panel keys.
Purpose
To check operation of all the keys and LEDs on the operation panel.
Method
1. Press the start key.
2. "1" appears on the copy quantity display and the leftmost LED on the operation panel lights.
3. As the keys lined up in the same line as the lit indicator are pressed in the order from the top to the bottom,
the figure shown on the copy quantity display increases in increments of 1. When all the keys in that line
are pressed and if there are any LEDs corresponding to the keys in the line on the immediate right, the top
LED in that line will light.
4. When all the keys on the operation panel have been pressed, all the LEDs light for up to 10 seconds.
5. When the LEDs go off, press the start key. All the LEDs light for 10 seconds again.
Completion
Press the stop/clear key. The indication for selecting a maintenance item No. appears.
• After checking numeric key 1, the operation cannot be canceled until all the keys are checked.
U243 Checking the operation of the DF motors
Description
Turns the motors in the optional DF on.
Purpose
To check the operation of the DF motors.
Method
1. Press the start key.
2. Select the motor to be operated using the copy exposure adjustment keys.
3. Press the start key. The operation starts.
Display (copy exposure indicator)
F-0 (exp. 1)
C-0 (exp. 2)
4. To turn each motor off, press the stop/clear key.
Completion
Press the stop/clear key when operation stops. The indication for selecting a maintenance item No. appears.
Description
Description
None
The key card is installed
The key counter is installed
Motor
Original feed motor (OFM)
Original paper conveying motor (OCM)
2AV/X
1-4
1-4-85