2AV/X
4. Insert the locating ball on each of the scanner
wires into the hole in the respective scanner
wire drum and wind the scanner wire three
turns inward and four turns outward.
• With the locating ball as the reference point,
wind the shorter end of each of the wires
inward.
5. Secure the scanner wires using the scanner
wire stoppers.
6. Refit the scanner wire drum shaft to the
scanner unit.
1-6
7. Insert the two frame securing tools into the
positioning holes at the front and rear of the
scanner unit to pin the mirror 2 frame in
position.
1-6-22
Scanner wire stoppers
Three turns
Locating ball
Four turns
Scanner wire drum
Frame securing tools
Three turns
Four turns
Figure 1-6-31
Mirror 2 Frame
Figure 1-6-32