Kyocera Mita KM-1530 Service Manual page 186

2AV/X
6. Open the front cover and remove the image
formation unit (see page 1-6-40).
7. Remove the stop ring from the paper feed
shaft unit (machine front).
8. Push the paper feed shaft unit toward the
machine rear (in the direction of 1) and
remove the unit from the lower front side (in
the direction of 2).
1-6
9. Remove the screw holding each of the upper
paper feed pulleys and then the pulleys.
10. Replace the upper paper feed pulleys and
refit all the removed parts.
• Before returning the drawer, turn the main
switch on and check that the upper paper
feed pulleys are positioned correctly (the
semicircular pulleys should be facing
downward).
1-6-4
Stop ring
Figure 1-6-4
Paper feed shaft unit
Figure 1-6-5
Upper paper feed pulleys
Figure 1-6-6