Table of Contents
Advertisement
DHCP Server Configuration
DHCP Server
When enabled, the DHCP server will assign an IP addresses to each device connected to the Ethernet port. IP
addresses assigned will be in the defined range (see below) and on the same subnet as the Fusion.
Dynamic Leases (Start IP Address/End IP Address)
External LAN devices connected to the Fusion will be assigned IP address in this range when DHCP is enabled. This
range of IP addresses must be on the same subnet as Fusion (the range must be compatible with the IP address and
network mask set for the Ethernet interface).
IP Configuration
Mode
Select Dynamic or Static. If you select Dynamic, the rest of the entries on this page will be shaded out.
IP Address
Static address for this interface. It must be on the same subnet as the gateway.
Subnet Mask
Will be assigned by the gateway.
Gateway
IP address of the Gateway (DHCP host). If not known this can be left as all zeros.
DNS Server 1, DNS Server 2
IP address of the DNS server for this unit. If not known, this can be left as all zeros.
NAT Configuration
NAT
Enable or Disable NAT (Network Address Translation)
3.3.3 CONNECTION MANAGER
The Connection Manager tab allows you to configure the Fusion router to set criteria that determine whether a reliable
connection exists or the link is down. This feature can also be used to only generate pings on an interface if no traffic is
sent via this interface. This can be useful to maintain an active connection. Connection Manager features are available
when the interface is configured for WAN mode only and are not applicable or available when the interface is
configured for LAN.
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 24
Advertisement
Table of Contents
