Table of Contents
Advertisement
2
GETTING STARTED
2.1
PACKAGE CONTENTS
Fusion LTE Modem
Power Cable
Mounting Bracket and hardware (Fixed or Mobile depending on device purchased)
Quick Start Guide
2.2
POWER SUPPLY CONNECTION
The fusion is shipped with a DC power cable used to connect the device to a DC source. The cable includes a fuse holder.
Insert the fuse in the power cable fuse holder prior to powering on the unit. The cable connections are listed below.
Pin
Wire Color
Description
1
Red
V IN
2
Black
Ground
3
White
Ignition Sense
4
Yellow
External Alarm Input
2.3
DEVICE CONNECTIONS
1. Insert the SIM/UICC card into the SIM/SVC slot as shown. If your solution requires only one cellular module, insert
the SIM into the slot corresponding to the populated module (WWAN0 (left), WWAN1 (right). If you are using a
dual card solution, you will need a SIM card in each slot.
2. Connect the antennas to the appropriate connectors on the front panel of the Fusion LTE modem.
3. Connect an Ethernet cable into the Eth1 port and plug the other end into the network port of your PC.
4. Connect the Power Cable to the modem PWR port and connect to an acceptable DC power source (10-30VDC).
Notes
DC input power lead, 13.8V nominal (10V to 30V range)
Connect to power supply ground
Standard ignition-on signal. Maximum voltage above which Ignition_sense
will be detected as ignition asserted = 9.0V;
If IGN Sense not used, this line must be connected to VIN
External alarm input, (active low) can be left floating if not used
17
Advertisement
Table of Contents
