General Settings; Unit Id - CalAmp Fusion User Manual

must have a unique IP address that (with the subnet mask) specifies a subnet that is separate (non-overlapping)
from subnets specified for any of the other Fusion interfaces.
Table 10 Possible states of Fusion interfaces
ETH (LAN) ETH (WAN)
Unknown Unknown
Disabled Disabled
Inactive Inactive
No Cable No Cable
Configuring IP Acquiring IP
Connecting Connecting
Connected Connected
IP Address
Displays the IP address assigned to this interface.
Subnet Mask
Displays the subnet mask of this interface
MAC Address
Media Access Control Address; every interface (i.e. LAN or WAN) has a unique hardware serial number or MAC
address to identify each Network Device from all others. Note that the optional WiFi client and Access Point
interfaces are provided by the same hardware module and therefore share the same MAC address.
3.2

GENERAL SETTINGS

The General Settings page allows customization of basic settings of the Fusion. Select General Settings from the main
navigation menu to navigate to the General Settings page. The General Settings page contains three tabs: Unit ID, Unit
Password, and Dynamic DNS.

3.2.1 UNIT ID

Figure 13 General Settings – Unit ID
ID
This identifier serves to distinguish this unit from other units in the network. This identification number is also the
TAIP identification used for GPS reporting and serves as the 'syslocation' for the SNMP facility.
WiFi AP WiFi Client
Unknown Unknown
Disabled Disabled
Inactive Inactive
Configuring IP Scanning
Connecting Acquiring IP
Connected Connecting
Connected
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
WWAN Serial
Unknown Unknown
Disabled Down
Disconnected Disabled
Connecting Listening
Connected No Cable
Connecting
Connected
| Page 17