Table of Contents
Advertisement
3.7.4 CONNECTION MANAGER
Figure 37 WWAN0 / WWAN1 – Connection Manager
The Connection Manager tab allows you to configure the Fusion router to set criteria that determine whether a reliable
connection exists or the link is down. This feature can also be used to only generate pings on an interface if no traffic is
sent via this interface. This can be useful to maintain an active connection.
Active Disconnection Probe
Enable
Check this box to detect link connection status based on pings to a specified IP address or the WAN's Gateway.
Ping Interval
Interval in seconds between each ping if no packets have been received. Verizon recommends a value of 1000
seconds (16 minutes and 40 seconds) and prohibits values of less than 300 seconds (5 minutes).
Ping this WAN's Gateway
To ping the WAN's Gateway rather than a specific IP address, check this box.
Ping this IP Address
Enter the IP address that pings will be sent to, to detect the link state. Enter the IP address of a known external
reachable server or network (for example, 8.8.8.8).
Force link down
Specify the number of pings, if which are unsuccessful, the link will be declared down. If disabled, the interface will
never be forced down if pings fail.
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 47
Advertisement
Table of Contents
