Table of Contents
Advertisement
ETH configured as a WAN
Figure 19 ETH0 / ETH1 / ETH2 – IP Settings (configured as WAN)
Modes of Operation
Type
Select LAN if this Ethernet port is connecting to a local area network. Select WAN if the Fusion is connecting to a
wide area network through an external router or gateway.
IP Configuration
IP Address/Subnet Mask
Sets the IP Address and Subnet Mask for the Ethernet interface.
Note: When assigning IP addresses, each interface, ETH0, ETH1, and ETH2, (and WiFi, WWAN0, and WWAN1, when
active) must have a unique IP address that (with the subnet mask) specifies it is on a subnet that is separate (non-
overlapping) from subnets specified for any of the other Fusion interfaces.
MTU
Maximum Transmission Unit, maximum packet size allowed to be transmitted. Should be left as default value of
1500 in most cases.
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 23
Advertisement
Table of Contents
