Lan Configuration - CalAmp Fusion User Manual

2. Connect the cellular antennas to the appropriate SMA connectors on the front of the Fusion router as shown in the
following figure, matching the antennas for the WWAN0 module with WAN0 connectors, and antennas for the
WWAN1 with WWAN1 connectors if applicable. For each antenna pair, connect the main Rx/Tx antenna to the
connector labeled M, and MIMO/Diversity to the secondary (unmarked) connector of the pair.
3. Connect a GPS antenna to the SMA connector labeled GPS and connect WiFi antennas to the RP-SMA connectors:
one for the Main (WiFi M) and one or more (as equipped) for WiFi MIMO/Diversity (unlabeled).
4. Connect an Ethernet cable into the ETH1 port (center Ethernet connector) of the Fusion and plug the other end into
the Ethernet port of your PC.
5. Connect the Power Cable to the modem PWR port and connect to an acceptable DC power source (10-30 VDC). The
DC power cable shipped with the Fusion to connect the unit to DC power includes a fuse holder. Insert the fuse in
the power cable fuse holder before powering the unit. Cable connections are listed in the Table 9 DC Power Cable
Pin-out.
After power is applied, the Fusion Power LED will illuminate solid red for 1 second, then turn solid amber for 5-6
seconds, blink amber for 6 seconds, and then turn solid green.
2.4

LAN CONFIGURATION

The Fusion contains a DHCP server which will automatically assign an IP address to your PC, however in some cases the
user may need to change the network settings on their PC to accept the IP address from the Fusion. Before powering
on the unit, confirm that your PCs Ethernet port is set up to receive an IP address from an external DHCP server,
confirm it is not set to a static address. The process required to do this differs depending on the version of Windows
you are using.
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 11