Normal Power-Up Sequence; Antenna - CalAmp Fusion User Manual

1.7.1 NORMAL POWER-UP SEQUENCE

Step Action
1 Apply power to the unit.
2 Internal 5-V power supply turns on.
3 Internal 1.8 V and 3.3 V power supply turn on.
4 Hardware initialization.
5 Bootstrap program runs.
6 Application starts.
7 Application runs normally.
1.8

ANTENNA

LTE antenna connections are SMA female connectors and must be used with antenna with SMA male connectors.
When using a direct mount or rubber duck antenna, choose the antenna specific to your band requirements. Mounting
options and cable lengths are user's choice and application specific. Each WWAN interface supports a primary and
diversity antenna connector.
Connect an active 3 - 5.5 V GPS antenna, with an average gain greater than -5 dBi, if using the GPS functionality.
Fusion routers are available with WiFi options, using RP-SMA connectors. Depending on the model, connect each WiFi
antenna to the proper connector. If equipped with a simple non-MIMO WiFi option, connect the primary WiFi antenna
to the connector labeled "M." For Fusions equipped with MIMO WiFi (2×2 or 3×3 MIMO), connect the WiFi antennas to
any free RP-SMA connector.
This device is factory configured with default settings and is ready to be customized via the internal HTML interface
that can be accessed using a Web browser through an Ethernet connection.
LED Activity
N/A
Power LED on front panel illuminates red for
approximately 1 second.
Every indicator, (except Ethernet jack indicators)
illuminate amber for approximately 400 milliseconds.
Every indicator turns off, except Power, which
remains amber.
Power LED blinks amber.
Power LED illuminates solid green.
Power LED remains solid green. Status LED on back
panel illuminates solid green.
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 9