Statistics - CalAmp Fusion User Manual

High-performance multi-band lte router
Hide thumbs Also See for Fusion:
Table of Contents

Advertisement

DHCP Server
DHCP Server
When enabled, the DHCP server will assign an IP addresses to each device connected to the Ethernet port. IP
addresses assigned will be in the defined range (see below) and on the same subnet as the Fusion.
Dynamic Leases (Start IP Address/End IP Address)
External LAN devices connected to the Fusion will be assigned IP address in this range when DHCP is enabled. This
range of IP addresses must be on the same subnet as Fusion (the range must be compatible with the IP address and
network mask set for the WiFi interface).
Static Leases
Allows you to assign and lease IP addresses to devices on your network, based on the specific MAC address of each.
Other
Lease Duration
Length of time in seconds that leases will last for IP addresses assigned.
Domain Name Suffix
If not known, this can be blank.
DNS Server 1, DNS Server 2
IP address of the DNS server for this unit. If not known, this can be left as all zeros.

3.5.4 STATISTICS

Figure 27 WiFi (Access Point) – Statistics
The statistics page lists the total number of packets and bytes transmitted and received since the time the units status
was listed as connected. These numbers reset to 0 when the interface disconnects.
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 32

Advertisement

Table of Contents
loading

Table of Contents