Table of Contents
Advertisement
3.6
WIFI (CLIENT)
Select WiFi (Client) from the main navigation menu to access the WiFi (Client) page which contains tabs for status and
configuration of the WiFi Client interface.
Note: Until Release 1.1.7 of the Fusion firmware, the Fusion could only be set to function as either a WiFi Client or a
WiFi Access Point, but not both simultaneously. Fusion firmware version 1.1.7 added the capability to configure the
Fusion as both a WiFi Client and WiFi Access Point simultaneously. However, since both the Access Point and the Client
use the same radio, once the radio channel is set for the Access Point, the Client must use the same channel. The client
will only look for external Access Points with the same WiFi radio channel that is selected for its own internal Access
Point. The client will not scan for Access Points using any other channels. For more information about using the Fusion
WiFi interface in concurrent or non-concurrent modes, see APPENDIX E— WiFi Concurrent Configuration as Access
Point and Client.
3.6.1 STATUS
Figure 28 WiFi (Client) – Status
| Page 33
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
Advertisement
Table of Contents
