Cell Connection - CalAmp Vanguard 3000 User Manual

Unit ID
• ID
This identification number serves to distinguish this unit from other units in the network. This Identification number
is also the TAIP identification used for GPS reporting and serves as the 'syslocation' for the SNMP facility.
Power Management
The Vanguard 3000 is designed to stay ON even if the ignition is turned off. The unit can be configured to automatically
shut down 1, 5, 30, 60 or 240 minutes after ignition has been turned off or when the supply voltage drops to a certain
level.
• Shutdown Method
Disabled by default. Select "Power off" to enable power management.
• After Ignition Line Off
Select between the following time intervals: 1, 5, 30, 60 or 240 minutes.
• When Voltage Drops Below
Enter desired voltage. Enter "0" to disable (and give precedence to time delay configured under "After Ignition Line
Off," above).
Network Time
The Vanguard 3000 is capable of maintaining the current time (UTC) by synchronizing itself with a Network Time
Protocol (NTP) Server. The user may specify a server URL and how frequently the router should synchronize with the
server. The router must have an internet connection to synchronize with the server. The router does not save or track
time while powered off, so time will be inaccurate until the router can connect with the server.
• NTP Client
Disabled by default. Select Enabled to activate the router's NTP client to synchronize with the specified server.
• NTP Server
Enter the URL of the desired NTP Server. Most NTP Servers have a posted usage policy. A review usage policies and
the choice of an appropriate server is recommended.
• Update Frequency
Set to 24 hours by default. Specify the frequency to synchronize the router time with the specified NTP Server.
3.2

CELL CONNECTION

Select Cell Connection from the left navigation pane to access the carrier, GSM, CDMA, System Monitor, and Dynamic
DNS settings tabs.
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
| Page 21