Table of Contents
Advertisement
3.3
ETH0, ETH1, ETH2 (ETHERNET 0, 1, AND 2)
The same instructions apply to settings for all Ethernet interfaces. (Except if the Fusion is equipped with the GeminiG3
narrowband WAN option. If this is the case, see 3.4 GeminiG3 (ETH2)). Each Ethernet interface can be configured as a
LAN or a generic WAN. Select the interface, ETH0, ETH1, or ETH2, as applicable, from the main navigation menu to
navigate to the page for the interface.
Note: When assigning IP addresses, each interface, ETH0, ETH1, and ETH2 (and WiFi, WWAN0, and WWAN1, when
active) must have a unique IP address that (with the subnet mask) specifies it is on a subnet that is separate (non-
overlapping) from subnets specified for any of the other Fusion interfaces.
3.3.1 STATUS
ETH configured as a LAN
Figure 16 ETH0 / ETH1 / ETH2 – Status (configured as LAN)
ETH configured as a WAN
Figure 17 ETH0 / ETH1 / ETH2 – Status (configured as WAN)
| Page 20
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
Advertisement
Table of Contents
