Table of Contents
Advertisement
3.8.3 IP SETTINGS
Figure 41 Serial – IP Settings
Mode
Sets the mode for Serial IP communication. Supported modes are UDP, TCP Server, or TCP Client.
Incoming Friendly IP Address
IP address from which packets received. This feature can be disabled by entering 0.0.0.0
Local Port
The port number assigned to the serial IP port on which communications will take place.
Remote Host IP Address
The IP address of the remote UDP mode serial endpoint.
Remote Host Port
The port of the remote UDP mode serial endpoint.
TCP Server Inactivity Timeout
Amount of time (in seconds) to wait when no data is sent or received over the TCP session before closing it.
TCP Server Hard Timeout
Amount of time (in seconds) to wait after a TCP session is established before closing it.
TCP Client Keep Alive, TCP Client Keep Alive Probes, TCP Client Keep Alive Intvl
The TCP Client keep-alive parameters are used to detect idle TCP client sessions and to close them after inactive for
the specified length of time.
Log Disabled/Enabled
When logging is enabled, the file /var/log/serialpad.log will be created inside the unit. It will contain debugging
information about activities related to the serial port. The log is lost when the Fusion is powered down.
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 52
Advertisement
Table of Contents
