Statistics - CalAmp Fusion User Manual

High-performance multi-band lte router
Hide thumbs Also See for Fusion:
Table of Contents

Advertisement

Received Packet Disconnection Probe
Enable
Check this box to enable link detection based on whether packets are received.
Force link down after
Enter the number of seconds after which, if no packets have been received, the link will be declared down.
RSSI-based Disconnection Probe
Enable
Check this box to determine the status of the link based on whether RSSI drops below a minimum threshold for a
specified duration.
Min RSSI Threshold
Enter the minimum RSSI.
Force link down after
Enter the number of seconds for which, if RSSI drops below the specified threshold, the link will be determined to
be down.
LTE Monitor
Enable
Check this box to enable the LTE Monitor.
Force LTE switch after
Enter the number of minutes between attempts to switch to LTE.
Quiet time required
Enter the number of seconds for which no traffic on the WWAN interface will cause an attempt to switch to LTE.

3.7.5 STATISTICS

Figure 38 WWAN0 / WWAN1 – Statistics
The statistics page lists the total number of packets and bytes transmitted and received since the time the units status
was listed as connected. These numbers reset to 0 when the interface disconnects.
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 48

Advertisement

Table of Contents
loading

Table of Contents