Table of Contents
Advertisement
Signal Quality
Indicator of the quality of the RF signal.
RSSI
Received Signal Strength indication. An indication of the power level of the signal being received by the wireless
interface.
Bit Rate
Measurement of over-the-air throughput. This will be affected by the type of access point (b, g, or n) and the
number of WiFi antennas (1, 2, or 3) installed on the Fusion router.
Click Refresh to update the page to show the most current information.
3.6.2 WIRELESS SETTINGS
Figure 29 WiFi (Client) – Wireless Settings
This page allows you to enter settings to allow the WiFi client to connect to access points automatically. The
parameters entered on this page are the same as in the WiFi Access Point section, except when operating in the client
mode the parameters must match those entered on the access point for the WiFi client to connect successfully.
As you add completed information for each access point, the access point will be listed in the Access Point Table at the
bottom of the page.
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 35
Advertisement
Table of Contents
