Table of Contents
Advertisement
Channel
GeminiG3 RF Channel used to communicate with the Paragon4.
IP Address
GeminiG3 RF IP address.
Subnet Mask
GeminiG3 RF subnet mask.
3.5
WIFI (ACCESS POINT)
Select WiFi (Access Point) from the main navigation menu to navigate to the WiFi (Access Point) page, which contains
tabs for status and configuration of the WiFi Access Point interface.
Note: Until Release 1.1.7 of the Fusion firmware, the Fusion could only be set to function as either a WiFi Client or a
WiFi Access Point, but not both simultaneously. Fusion firmware version 1.1.7 added the capability to configure the
Fusion as both a WiFi Client and WiFi Access Point simultaneously. However, since both the Access Point and the Client
use the same radio, once the radio channel is set for the Access Point, the Client must use the same channel. The client
will only look for external Access Points with the same WiFi radio channel that is selected for its own internal Access
Point. The client will not scan for Access Points using any other channels. For more information about using the Fusion
WiFi interface in concurrent or non-concurrent modes, see APPENDIX E— WiFi Concurrent Configuration as Access
Point and Client.
3.5.1 STATUS
Figure 24 WiFi (Access Point) – Status
Status
Interface Status
See Table 10 Possible states of Fusion interfaces in Unit Status.
Interface Up Time
Number of days, hours, minutes, and seconds that the interface has been up (connected state).
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 28
Advertisement
Table of Contents
