Table of Contents
Advertisement
1. Connect a PC running Windows XP or Windows®7 to the Fusion as shown in Figure 77 for OTA firmware upgrade or
as shown in Figure 78 for direct cable connection firmware upgrade.
a. For direct cable connection firmware upgrade, connect the Ethernet cable from the PC to the Ethernet jack
labeled ETH1 (center of the three Ethernet jacks).
b. Connect the 12 V DC power supply to the Power connector of the Fusion router. Connect the 12 V DC power
supply to 110 V AC power.
2. On the PC, open a web browser and enter the IP address of the Fusion router in the address bar.
When the PC is connected to the Ethernet jack labeled ETH1, the default IP address is 192.168.1.50.
In the Windows task bar you may need to refresh (click repair) the network connection for the Ethernet port if
you connected the cable after booting the PC or Fusion.
3. A Web Server Authentication window appears as shown in Figure 8 on page 13. (This may take up to 90 seconds
after power is applied to the Fusion.) For the default User Name and Password see page 13. Click OK to log on.
4. Select Maintenance from the main navigation menu to navigate to the Maintenance page and then select the
WWAN Firmware tab.
Figure 81 Maintenance – WWAN Firmware Upgrade Upload File (Browse to firmware upgrade package.)
5. Click Browse (or Choose File in some browsers — the button near the bottom of the WWAN Firmware tab) in the
Upgrade WANx Firmware section and navigate to the firmware upgrade package file. (Firmware upgrade package
file names may vary by module manufacturer and model and by cell provider.) Click Open to select the file and
then click Apply to upload and apply the firmware upgrade package.
If there are more than one cell modules in the Fusion, the Fusion has the intelligence programmed into it to
distinguish from the package contents which cell module the firmware upgrade is for.
6. The Fusion router displays the message "Uploading new firmware. Please wait..." as it uploads the firmware
upgrade, which may take up to fifteen minutes to finish. When it has finished uploading the upgrade package, the
Fusion displays a message that says "Successfully installed the new firmware," followed by the file name and file
size of the package file.
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 104
Advertisement
Table of Contents
