Table of Contents
Advertisement
Data Compression
Enable this to request IPComp (IP Payload Compression Protocol) data compression to improve performance. This
must be supported by the peer.
Dead Peer Detection Delay
Amount of idle time (no packets received from tunnel) before sending a remote peer probe packet.
Dead Peer Detection Timeout
Remote peer probe response timer.
Dead Peer Detection Action
Action to be taken when a remote peer probe timeout value is reached.
As you complete entry of the above fields for each tunnel to be created, click Add to save the new tunnel item and add
it to the Tunnel Table.
Tunnel Table
Enable
Check the Enable box to enable a tunnel once it has been defined and added to the table. This tunnel state is saved
across resets of the Fusion.
Status
Click the View link to open a page showing the log of the tunnel's negotiation activity.
Edit
To edit a tunnel that has been added to the Tunnel Table, click the Edit link for the tunnel. The parameters defining
the tunnel are re-loaded into the fields in the Tunnel Configuration section of the tab.
― Clicking the Add button and leaving the tunnel ID number unchanged saves your changes to the selected tunnel.
― To perform a "Save as," to create a new tunnel with similar characteristics (except the parameters you change),
leaving parameters for the selected tunnel unchanged, enter a new ID and then click Add and the new tunnel is
added to the Tunnel Table.
Delete
If it is necessary to delete a tunnel, click the Delete button that appears in the row for the tunnel to be deleted.
3.10.2 HTTPS
Figure 51 Security – HTTPS
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 66
Advertisement
Table of Contents
