CalAmp Fusion User Manual page 48

High-performance multi-band lte router
Hide thumbs Also See for Fusion:
Table of Contents

Advertisement

Status
Interface Status
See Table 10 Possible states of Fusion interfaces in Unit Status.
Interface Up Time
Number of days, hours, minutes, and seconds that the interface has been up (connected state).
IP
IP Address
WWAN IP address of the Fusion. This will be assigned by the carrier.
Subnet Mask
The subnet mask assigned by the carrier. This value will be dictated by the IP address assigned.
Note: Each of the Fusion interfaces, ETH0, ETH1, and ETH2, WiFi, and WWAN0 (and WWAN1, when active) must
have a unique IP address that (with the subnet mask) specifies it is on a subnet that is separate (non-overlapping)
from subnets specified for any of the other Fusion interfaces. IP addresses and subnet masks for the Fusion WWAN
interfaces are normally determined and set by the network provider or carrier and specify a different subnet class
than typically specified for the ETH and WiFi interfaces, and therefore are not likely to incur any overlapping subnet
issues.
Gateway
IP address of the WAN gateway. This is used for routing packets to remote networks
DNS Server 1, DNS Server 2
IP address of the (1) preferred and (2) alternate DNS server.
MTU
The Maximum Transmission Unit size, maximum packet size allowed to be transmitted. Should be left as default
value of 1500 in most cases.
Link
Status
See Table 10 Possible states of Fusion interfaces in Unit Status.
RSSI
Indication of the signal strength of the carrier network.
RSRQ
Reference Signal Received Quality.
Operating Mode
The RF technology currently active. Example: LTE, UMTS, or CDMA.
Carrier
Wireless network provider.
APN
The Access Point Name currently being used.
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 42

Advertisement

Table of Contents
loading

Table of Contents