Table of Contents
Advertisement
In the Provider #1 section, if Provider #1 is not already enabled click Enabled and in the same section, click Save to
enable Provider #1.
Leave APN, User, and Password blank unless you have received specific values from your carrier. For most cases,
Authentication should remain set as Any.
It may take several minutes to establish the connection after it has been enabled for the first time. Verify the
connection is active by clicking the Status tab. See the following figure.
Figure 10 WWAN0 Status tab showing LTE Link connected
| Page 14
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
Advertisement
Table of Contents
