Restore Configuration; Figure 35-6 Successful Backup Confirmation Screen; Figure 35-7 Telnet Into Menu 24.6 - ZyXEL Communications ZyWALL 5 User Manual

ZyWALL 5 Internet Security Appliance
After a successful backup you will see the following screen. Press any key to return to the SMT
4.
menu.

35.4 Restore Configuration

This section shows you how to restore a previously saved configuration. Note that this function erases
the current configuration before restoring a previous back up configuration; please do not attempt to
restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your ZyWALL since
FTP is faster. Please note that you must wait for the system to automatically restart after the file
transfer is complete.
WARNING!
Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE YOUR ZyWALL. When the Restore
Configuration process is complete, the ZyWALL will automatically
restart.
35.4.1 Restore Using FTP
For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file upload in
this chapter.
Menu 24.6 -- System Maintenance - Restore Configuration
To transfer the firmware and configuration file to your workstation,
follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Type "put backupfilename rom-0" where backupfilename is the name of
your backup configuration file on your workstation and rom-0 is the
remote file name on the router. This restores the configuration to
your router.
4. The system reboots automatically after a successful file transfer
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must
remain
in this menu to back up using TFTP), please see your router manual.
Launch the FTP client on your computer.
1.
Enter "open", followed by a space and the IP address of your ZyWALL.
2.
35-6
** Backup Configuration completed. OK.
### Hit any key to continue.###

Figure 35-6 Successful Backup Confirmation Screen

Press ENTER to Exit:

Figure 35-7 Telnet into Menu 24.6

Firmware and Configuration File Maintenance