Figure 28-7 Menu 11.5: Remote Node Filter (Pppoe Or Pptp Encapsulation); Figure 28-8 Menu 11.6: Traffic Redirect Setup; Table 28-5 Menu 11.6: Traffic Redirect Setup - ZyXEL Communications ZyWALL 5 User Manual

ZyWALL 5 Internet Security Appliance

Figure 28-7 Menu 11.5: Remote Node Filter (PPPoE or PPTP Encapsulation)

28.5.1 Traffic Redirect Setup
Configure parameters that determine when the ZyWALL will forward WAN traffic to the backup
gateway using Menu 11.6 — Traffic Redirect Setup.
The following table describes the fields in this screen.
FIELD
Active Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic
redirect setup. The default is No.
Configuration:
Backup Enter the IP address of your backup gateway in dotted decimal notation.
Gateway IP
The ZyWALL automatically forwards traffic to this IP address if the ZyWALL's
Address
Internet connection terminates.
Metric Enter a number from 1 to 15 to set this route's priority among the ZyWALL's
routes (see the Metric section in the WAN and Dial Backup Setup chapter)
The smaller the number, the higher priority the route has.
28-8
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Menu 11.6 - Traffic Redirect Setup
Active= No
Configuration:
Backup Gateway IP Address= 0.0.0.0
Metric= 14
Check WAN IP Address= 0.0.0.0
Fail Tolerance= 2
Period(sec)= 5
Timeout(sec)= 3
Press ENTER to Confirm or ESC to Cancel:

Figure 28-8 Menu 11.6: Traffic Redirect Setup

Table 28-5 Menu 11.6: Traffic Redirect Setup

DESCRIPTION EXAMPLE
Yes
0.0.0.0
15
(default)
Remote Node Setup