Remote Node Profile (Backup Isp); Table 24-4 Advanced Wan Port Setup: Call Control Parameters - ZyXEL Communications ZyWALL 5 User Manual

ZyWALL 5 Internet Security Appliance
Table 24-3 Advanced WAN Port Setup: AT Commands Fields
FIELD
Drop DTR When Hang Press the [SPACE BAR] to choose either Yes or No. When Yes is
Up selected (the default), the DTR (Data Terminal Ready) signal is
dropped after the "AT Command String: Drop" is sent out.
AT Response Strings:
CLID (Calling Line Enter the keyword that precedes the CLID (Calling Line Identification)
Identification) in the AT response string. This lets the ZyWALL capture the CLID in
the AT response string that comes from the WAN device. CLID is
required for CLID authentication.
Called Id Enter the keyword preceding the dialed number.
Speed Enter the keyword preceding the connection speed.

Table 24-4 Advanced WAN Port Setup: Call Control Parameters

FIELD
Call Control
Dial Timeout (sec) Enter a number of seconds for the ZyWALL to keep trying to set up
an outgoing call before timing out (stopping). The ZyWALL times
out and stops if it cannot set up an outgoing call within the timeout
value.
Retry Count Enter a number of times for the ZyWALL to retry a busy or no-
answer phone number before blacklisting the number.
Retry Interval (sec) Enter a number of seconds for the ZyWALL to wait before trying
another call after a call has failed. This applies before a phone
number is blacklisted.
Drop Timeout (sec) Enter a number of seconds for the ZyWALL to wait before dropping
the DTR signal if it does not receive a positive disconnect
confirmation.
Call Back Delay Enter a number of seconds for the ZyWALL to wait between
(sec) dropping a callback request call and dialing the co-responding
callback call.

24.6 Remote Node Profile (Backup ISP)

Enter 2 in Menu 11 Remote Node Setup to open Menu 11.1 Remote Node Profile (Backup ISP)
(shown below) and configure the setup for your Dial Backup port connection.
24-4
DESCRIPTION
DESCRIPTION
DEFAULT
YES
NMBR =
TO
CONNECT
DEFAULT
60 seconds
0 to disable the
blacklist control
20 seconds
15 seconds
WAN and Dial Backup Setup