Wireless Lan Setup; Figure 25-6 Menu 3.5: Wireless Lan Setup - ZyXEL Communications ZyWALL 5 User Manual

FIELD
Version Press [SPACE BAR] and then [ENTER] to select the RIP version.
Options are
RIP-1, RIP-2B or RIP-2M.
Incoming Protocol Enter the filter set(s) you wish to apply to the incoming traffic between
Filters this node and the ZyWALL.
Outgoing Protocol Enter the filter set(s) you wish to apply to the outgoing traffic between
Filters this node and the ZyWALL.
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm...] to save your
configuration, or press [ESC] at any time to cancel.

25.5 Wireless LAN Setup

Use menu 3.5 to set up your ZyWALL as the wireless access point.
See the chapter on wireless LAN for instructions on WEP and configuring the MAC address filter.
If you are configuring the ZyWALL from a computer connected
to the wireless LAN and you change the ZyWALL's ESSID or WEP
settings, you will lose your wireless connection when you press
[ENTER] to confirm. You must then change the wireless settings of
your computer to match the ZyWALL's new settings.
From the main menu, enter 3 to open Menu 3 – LAN Setup to configure the Wireless LAN setup. To
edit the wireless LAN configuration, enter 5 to open Menu 3.5 – Wireless LAN Setup as shown next.
The settings of all client stations on the wireless LAN must
match those of the ZyWALL.
Follow the instructions in the next table on how to configure the wireless LAN parameters.
LAN Setup
Table 25-3 Menu 3.2.1: IP Alias Setup
DESCRIPTION
Menu 3.5 - Wireless LAN Setup
Enable Wireless LAN= No
ESSID= Wireless
Hide ESSID= No
Channel ID= CH01 2412MHz
RTS Threshold= 2432
Frag. Threshold= 2432
WEP= Disable
Default Key= N/A
Key1= N/A
Key2= N/A
Key3= N/A
Key4= N/A
Edit MAC Address Filter= No
Press ENTER to Confirm or ESC to Cancel:

Figure 25-6 Menu 3.5: Wireless LAN Setup

ZyWALL 5 Internet Security Appliance
EXAMPLE
RIP-1
1
2
25-5