Configuring Dns; Figure 18-23 Dns; Table 18-6 Snmp - ZyXEL Communications ZyWALL 5 User Manual

ZyWALL 5 Internet Security Appliance
LABEL
SNMP Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests from the
management station. The default is public and allows all requests.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
SNMP
Service Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Service Access Select the interface(s) through which a computer may access the ZyWALL using this
service.
Secure Client IP A secure client is a "trusted" computer that is allowed to communicate with the ZyWALL
Address using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to access
the ZyWALL using this service.
Apply Click Apply to save your customized settings.
Click Reset to begin configuring this screen afresh.
Reset

18.15 Configuring DNS

Use DNS (Domain Name System) to map a domain name to its corresponding IP address and vice
versa. Refer to the WAN chapter for more information.
To change your ZyWALL's DNS settings, click REMOTE MGMT, then the DNS tab. The screen
appears as shown.
18-18

Table 18-6 SNMP

DESCRIPTION

Figure 18-23 DNS

Remote Management