Figure 35-3 System Maintenance: Backup Configuration; Figure 35-4 System Maintenance: Starting Xmodem Download Screen; Figure 35-5 Backup Configuration Example; Table 35-3 General Commands For Gui-Based Tftp Clients - ZyXEL Communications ZyWALL 5 User Manual

Table 35-3 General Commands for GUI-based TFTP Clients

COMMAND
Host Enter the IP address of the ZyWALL. 192.168.1.1 is the ZyWALL's default IP address
when shipped.
Send/Fetch Use "Send" to upload the file to the ZyWALL and "Fetch" to back up the file on your
computer.
Local File Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File This is the filename on the ZyWALL. The filename for the firmware is "ras" and for the
configuration file, is "rom-0".
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
Refer to section 35.3.5 to read about configurations that disallow TFTP and FTP over WAN.
35.3.9 Backup Via Console Port
Back up configuration via console port by following the HyperTerminal procedure shown next.
Procedures using other serial communications programs should be similar.
Display menu 24.5 and enter "y" at the following screen.
1.

Figure 35-3 System Maintenance: Backup Configuration

The following screen indicates that the Xmodem download has started.
2.

Figure 35-4 System Maintenance: Starting Xmodem Download Screen

Run the HyperTerminal program by clicking Transfer, then Receive File as shown in the
3.
following screen.
Firmware and Configuration File Maintenance
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
You can enter ctrl-x to terminate operation any
time.
Starting XMODEM download...

Figure 35-5 Backup Configuration Example

ZyWALL 5 Internet Security Appliance
DESCRIPTION
Type a location for storing the
configuration file or click Browse to
look for one.
Choose the Xmodem protocol.
Then click Receive.
35-5