Chapter 33 Snmp Configuration; Snmp Configuration; Snmp Traps; Figure 33-1 Menu 22: Snmp Configuration - ZyXEL Communications ZyWALL 5 User Manual

33.1 SNMP Configuration

To configure SNMP, enter 22 from the main menu to display Menu 22 - SNMP Configuration as
shown next. The "community" for Get, Set and Trap fields is SNMP terminology for password.
The following table describes the SNMP configuration parameters.

Table 33-1 SNMP Configuration Menu Fields

FIELD
Get Community Type the Get community, which is the password for the incoming Get-
and GetNext requests from the management station.
Set Community Type the Set community, which is the password for incoming Set
requests from the management station.
Trusted Host If you enter a trusted host, your ZyWALL will only respond to SNMP
messages from this address. A blank (default) field means your ZyWALL
will respond to all SNMP messages it receives, regardless of source.
Trap
Community Type the Trap community, which is the password sent with each trap to
the SNMP manager.
Destination Type the IP address of the station to send your SNMP traps to.
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC] to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

33.2 SNMP Traps

The ZyWALL will send traps to the SNMP manager when any one of the following events occurs:
SNMP Configuration
This chapter explains SNMP configuration menu 22.
Menu 22 - SNMP Configuration
SNMP:
Get Community= public
Set Community= public
Trusted Host= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:

Figure 33-1 Menu 22: SNMP Configuration

DESCRIPTION
ZyWALL 5 Internet Security Appliance
Chapter 33
SNMP Configuration
EXAMPLE
Public
Public
0.0.0.0
Public
0.0.0.0
33-1