Figure 35-13 Telnet Into Menu 24.7.1: Upload System Firmware; Figure 35-14 Telnet Into Menu 24.7.2: System Maintenance - ZyXEL Communications ZyWALL 5 User Manual

Menu 24.7.1 - System Maintenance - Upload System Firmware
To upload the system firmware, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "root" and
SMT password as requested.
3. Type "put firmwarefilename ras" where "firmwarefilename" is the name
of your firmware upgrade file on your workstation and "ras" is the
remote file name on the system.
4. The system reboots automatically after a successful firmware upload.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading system firmware using TFTP (note
that you must remain on this menu to upload system firmware using TFTP),
please see your manual.
Press ENTER to Exit:

Figure 35-13 Telnet Into Menu 24.7.1: Upload System Firmware

35.5.2 Configuration File Upload
You see the following screen when you telnet into menu 24.7.2.
Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload the system configuration file, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "root" and
SMT password as requested.
3. Type "put configurationfilename rom-0" where "configurationfilename"
is the name of your system configuration file on your workstation, which
will be transferred to the "rom-0" file on the system.
4. The system reboots automatically after the upload system configuration
file process is complete.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading configuration file using TFTP (note
that you must remain on this menu to upload configuration file using TFTP),
please see your manual.
Press ENTER to Exit:

Figure 35-14 Telnet Into Menu 24.7.2: System Maintenance

To upload the firmware and the configuration file, follow these examples
35.5.3 FTP File Upload Command from the DOS Prompt Example
Launch the FTP client on your computer.
1.
Enter "open", followed by a space and the IP address of your ZyWALL.
2.
Press [ENTER] when prompted for a username.
3.
Enter your password as requested (the default is "1234").
4.
Enter "bin" to set transfer mode to binary.
5.
Firmware and Configuration File Maintenance
ZyWALL 5 Internet Security Appliance
35-9