Introducing the Web Configurator
This chapter describes how to access the ZyWALL web configurator and provides an overview of its
screens.
2.1
Web Configurator Overview
The embedded web configurator (ewc) allows you to manage the ZyWALL from anywhere through a
browser such as Microsoft Internet Explorer or Netscape Navigator. Use Internet Explorer 6.0 and
later or Netscape Navigator 7.0 and later versions with JavaScript enabled. It is recommended that you
set your screen resolution to 1024 by 768 pixels. The screens you see in the web configurator may
vary somewhat from the ones shown in this document due to differences between individual firmware
versions.
2.2
Accessing the ZyWALL Web Configurator
Make sure your ZyWALL hardware is properly connected and prepare your computer/computer
1.
network to connect to the ZyWALL (refer to the Quick Start Guide).
Launch your web browser.
2.
Type "192.168.1.1" as the URL.
3.
Type "1234" (default) as the password and click Login. In some versions, the default password
4.
appears automatically - if this is the case, click Login.
You should see a screen asking you to change your password (highly recommended) as shown next.
5.
Type a new password (and retype it to confirm) and click Apply or click Ignore.
Click Apply in the Replace Certificate screen to create a certificate using your ZyWALL's MAC
6.
address that will be specific to this device.
Introducing the Web Configurator
Figure 2-1 Change Password Screen
ZyWALL 5 Internet Security Appliance
Chapter 2
2-1